Why wouldn’t you want to have a set of green ghosts around? Especially if your adventurers might be snooping around tombs. Ancient tombs, at that. There may even be mummies about. Boo.
The ghosts were hard to clean up. None of the heads came through attached, and on one of the ghosts the arms came off with the supports. They’ll still work (ok, headless ghosts) for the purpose of this adventure, but I do need to figure out a better way to print them.
- Maker: Harry Baere
- Source: spooky ghost
- License: Creative Commons – Attribution – Share Alike
- Model: ghost.stl x4
- Material: CNZhehan Translucent Green PETG 1.75mm
- Print Date: 2017/10/20
- Print Time: 2 hours 54 minutes
- Estimated Print Time: 2 hours 15 minutes
- Estimated Filament: 6.3 meters
- Slicer: PrusaControl
- Slicer Settings:
- 0.20mm
- 20% infill
- Supports Everywhere
- Include Brim
- Printer: Prusa i3 mk2