Makies Jack-o-Lantern

It was edging close to Halloween, and I just happened to have some translucent green and translucent orange filament on hand (imagine that), so a Jack-o-lantern seemed appropriate: Lit with a small LED, it had a nice glow to it: This is one of only a handful of models I’ve need to scale up for printing….

Bestiary – Ghosts

Why wouldn’t you want to have a set of green ghosts around? Especially if your adventurers might be snooping around tombs. Ancient tombs, at that. There may even be mummies about. Boo. The ghosts were hard to clean up. None of the heads came through attached, and on one of the ghosts the arms came off…

Wireframe Skull

In the spirit of Halloween, I tried out a wireframe skull model, intending it to be a pencil jar for the 10 year old. At default scale it’s unfortunately a bit small. Maybe a (singular) pencil jar… Interesting that the print time estimate was so far off when I used PrusaControl for the estimates as well as slicing.  …