Printing a simple test pattern with Hatchbox Wood Fill. This wood fill is a blend with standard PLA, but I’m trying out a PrusaControl slicer preset for ColorFabb wood fill, to see if the heat, speed, and retraction settings work equally well for Hatchbox.
Hmm – not the cleanest print on the test tile, but the brim was super smooth and clean. Will need to play with slicer settings and printer z adjustments for the full piece I want to print. I like the finish and aesthetic of the wood fill, so I hope it works well for a few other prints, and one or two special pieces I want to put together.
- Maker: –
- Source: custom test tile
- Original License: –
- Model: –
- GCode: –
- Material: Hatchbox Wood Fill PLA 1.75mm
- Print Date: 2017/11/12
- Print Time: 8 minutes
- Estimated Print Time: 8 minutes
- Estimated Filament: 42.4 cm
- Slicer: PrusaControl
- Slicer Settings:
- Material: ColorFabb Wood fill
- 0.20mm layers
- 20% infill
- include brim
- Printer: Prusa i3 mk2