Minions of a dangerous foe have a captive Bulette barely contained in a cage deep in the Undermountain. Nearly berserk with rage, the Bulette is likely as dangerous to the captors as to the adventurers.
Post print this model was relative easy to clean up, with support material holding up the bulk of the body:
After an initial coat of paint:
With a final top coat of enamel, mounted onto it’s base:
- Source: Land Shark
- Maker: Harrison Baere
- License: Creative Commons – Attribution – Share Alike
- Model: All Files
- Material: Prusa White PLA 1.75mm
- Print Date: 2018/01/28
- Print Time:
- Bulette: 4 hours 55 minutes
- Base: 2 hours 33 minutes
- Cleanup Time: 15 minutes
- Paint Time: 2 hours
- Estimated Print Time:
- Bulette: 5 hours 13 minutes
- Base: 2 hours 33 minutes
- Estimated Filament:
- Bulette: 4.1 meters
- Base: 1.6 meters
- Slicer: Cura 3
- Slicer Settings:
- 0.06mm layers
- 20% infill
- supports
- support line width: 0.2mm