Doll House Dresser

An original doll-house scale dresser design based on the discontinued 4 drawer Ikea Mandal dresser.

After the first test prints, I needed to widen the drawer rails by 0.5mm on each side, otherwise the drawers were just wide enough, with just enough rail, to slip out and drop down when pushed to one side.

The final design has drawers that are functional, fit nicely, and are solid enough in the drawer walls to not fall apart or break too easily.

Printing

All of the models are designed to print without supports, with the drawers requiring some assembly. For a full dresser you will  need to print:

  • 1x dresser-main.stl
  • 3x dresser-large.stl
  • 3x dresser-large-face.stl
  • 1x dresser-small.stl
  • 1x dresser-small-face.stl

Assembly

The drawer faces all need to be glued to their drawers. I suggest slotting all of the drawer bodies into the dresser body, and laying the dresser on its back. Lightly apply glue to the front edge of each drawer, and lay the drawer faces in place, adjusting as needed to align the faces. Let sit for 5 minutes, and the glue should be sufficiently cured to stand the dresser up. You can test the drawers at this point, but I recommend 24 hours of curing before using the drawers too much, otherwise you risk the drawer faces pulling off.

  • Source: Doll House Dresser
  • Maker: patricknevindwyer
  • License: Creative Commons – Attribution – Share-alike
  • Models: All Files
  • Materials:
    • Prusa White PLA 1.75mm
    • Hatchbox Red PLA 1.75mm
  • Scale: 1:12, doll house standard
  • Modeling Time: 2 hours
  • Print Date: 2018/02/11
  • Print Time:
    • Dresser:  4 hours 20 minutes
    • Drawer small: 38 minutes
    • Drawer small face: 9 minutes
    • Drawer large x3: 2 hours 14 minutes
    • Drawer large face x3: 46 minutes
  • Estimated Print Time:
    • Dresser: 4 hours 17 minutes
    • Drawer small: 39 minutes
    • Drawer small face: 10 minutes
    • Drawer large x3: 2 hours 8 minutes
    • Drawer large face x3: 44 minutes
  • Estimated Filament:
    • Dresser: 14.5 meters
    • Drawer small: 2.1 meters
    • Drawer small face: 0.6 meters
    • Drawer large x3: 6.9 meters
    • Drawer large face x3: 2.4 meters
  • Slicer: Cura 3
  • Slicer Settings:
    • 0.20mm layers
    • 20% infill
    • no supports

Leave a Reply

Your email address will not be published. Required fields are marked *