Cell phone stands seem to be a dime-a-dozen on Thingiverse. I decided to try this one out because it looked like it would maintain good balance, fit my iPhone with it’s case, and provided a slot to plug in a charging cable while on the stand. So far I have no complaints.
This was one of my first multi-hour prints after getting my Prusa i3 mk2, and was a fairly easy and straightforward print. This was also the first time I tried the pause print feature, leaving the partially completed print over night and resuming the next morning. There is a layer that is ever so slightly offset where the printer resumed, but otherwise flawless pause and restart.
- Maker: bqLabs
- Source: Smartphone and Tablet Stand
- Original License: Creative Commons – Attribution – Share Alike
- Model: cell_phone.stl
- GCode: cell_phone_0.10mm.gcode
- Material: Hatchbox Yellow PLA 1.75mm
- Print Date: 2017/08/31
- Print Time: –
- Slicer: Slic3r PE 1.36.2
- Slice Settings:
- 0.10mm Layers
- 20% infill, cubic
- No Supports
- Printer: Prusa i3 mk2