A few gift boxes for small presents.
The scaled down version was intended for small gifts, like jewelry, but ended up being very hard to close, and even harder to open. Seems like the mixture of scaling and print quality didn’t lend itself to the original tolerances between the top and bottom of the box.
The Gift Card size box turns out to be fairly quick to print, and well sized for jewelry:
To get really clean prints of the gift-card box I rotated the top and bottom before slicing, to minimize supports connected to the outside of the box.
In the end, the red and white gift-card sized boxes went under the tree.
- Maker: muddtt
- Source: Christmas Gift Box
- License: Creative Commons – Attribution – Non-commercial
- Models:
- Material:
- Inland Peak Green PLA 1.75mm
- Hatchbox Red PLA 1.75mm
- Prusa White PLA 1.75mm
- Print Date: 2017/12/23 – 2017/12/24
- Print Time:
- 60% scale
- Ribbon: 3 minutes
- Top: 26 minutes
- Bottom: 28 minutes
- Gift Card Box – 100% scale
- bottom: 1 hour 30 minutes
- top: 1 hour 50 minutes
- ribbon: 11 minutes
- 60% scale
- Estimated Print Time:
- 60% scale
- Ribbon: 3 minutes
- Top: 26 minutes
- Bottom: 26 minutes
- Gift Card Box – 100% scale
- bottom: 1 hour 24 minutes
- top: 1 hour 32 minutes
- ribbon: 8 minutes
- 60% scale
- Estimated Filament:
- 60% scale
- Ribbon: 12.1 cm
- Top: 2.7 meters
- Bottom: 2.7 meters
- Gift Card Box – 100% scale
- bottom: 9.8 meters
- top: 11.8 meters
- ribbon: 68.6 cm
- 60% scale
- Slicer: PrusaControl
- Slicer Settings:
- 0.30mm layers
- 20% infill
- 60% Scale
- Rotated for better printing
- Bottom
- No Brim
- No Supports
- Rotate 270° around X axis
- Top
- No Brim
- Supports from Bed
- Rotate 90° around X axis
- Printer: Prusa i3 mk2