I’m going to use Hyenas as a proxy for Goblin Dogs in this adventure. I wanted a decent sized pack, so setup a print with six copies of the small hyena:
There was a ton of clean up for these, and being delicate, two of them didn’t make it. That’s why I started with six, though. The base of the support plate under the Hyena at the base of the figurine still has a few layers of support material on it, which I’m not going to clean up, otherwise I’d probably lose most of the rest of the figurines.
The Hatchbox Copper ABS loaded a bit strangely; lots of popping and hissing as the hotend heated up, and the extruded filament almost looks aerated. The print came out a bit stringy as well – I may need to play with the print temperature for this filament to get better results.
- Maker: Harrison Braere
- Source: Hyena and Giant Hyena
- Original License: Creative Commons 3.0 – Attribution – Share Alike
- Model: hyena
- GCode: Hyena_x6.gcode
- Material: Hatchbox Copper ABS 1.75mm
- Print Date: 2017/10/01
- Print Time: 1 hour 4 minutes
- Estimated Print Time: 59 minutes (PrusaControl 0.9.3_390_beta)
- Estimated Filament: 6.2 meters (PrusaControl 0.9.3_390_beta)
- Slicer: Slic3r PE 1.37.1
- Slice Settings:
- Supports
- 4mm brim
- 10% infill
- 0.35mm layers
- Printer: Prusa i3 mk2