We’re building a dungeon. This is a project spanning lots of different prints, until we generate all of the tiles we need for the dungeon we have in mind. The prints are spread across:

• Summary – The Sewer Dungeon
• Print One – Sewer Corners
• Print Two – Sewer Tunnel
• Print Three – Corners and Ladders
• Print Four – Deep Pool
• Print Five – Deep Sluice and Deep Pool
• Print Six – Barred Sewer
• Print Seven – ABS Flooring
• Print Eight – Circular Room Part 1
• Print Nine – Circular Room Part 2
• Print Ten – Circular Room Part 3
• Print Eleven – Bridges
• Print Twelve – So Much Sluice
• Print Thirteen – Magic Portal

Print Eight – Circular Room Part 1

A circular room inset in a larger dungeon is going to play a part in this upcoming adventure. This print covers the curved walls of the room, while a series of future prints will add in the outside tiles to square out our floor against the curved wall, as well as a door, some straight walls, and a few filler floor tiles.

View this post on Instagram

A post shared by Dwyer Devices (@dwyerdevices)

The curves are 3×3, eventually making the room feel fairly large.

• Series: OpenForge Tiles
• Maker: devonjones
• Source: OpenForge Stone Dungeon Curved Walls
• Original License: Creative Commons – Attribution – Share Alike
• Model: stone_curved_3x3.stl x4
• GCode: –
• Material: Inland Gray ABS 1.75mm
• Print Date: 2017/09/28
• Print Time: 7 hours 37 minutes
• Estimated Print Time: 6 hours 24 minutes (PrusaControl 0.9.3_390_beta)
• Estimated Filament: 68.3 meters (PrusaControl 0.9.3_390_beta)
• Slicer: Slic3r
• Slice Settings:
  • 2mm brim
  • 0.35mm layers
  • 10% infill
  • No Supports
• Printer: Prusa i3 mk2