We’re building a dungeon. This is a project spanning lots of different prints, until we generate all of the tiles we need for the dungeon we have in mind. The prints are spread across:
- Summary – The Sewer Dungeon
- Print One – Sewer Corners
- Print Two – Sewer Tunnel
- Print Three – Corners and Ladders
- Print Four – Deep Pool
- Print Five – Deep Sluice and Deep Pool
- Print Six – Barred Sewer
- Print Seven – ABS Flooring
- Print Eight – Circular Room Part 1
- Print Nine – Circular Room Part 2
- Print Ten – Circular Room Part 3
- Print Eleven – Bridges
- Print Twelve – So Much Sluice
- Print Thirteen – Magic Portal
Print Three – Corners and Ladders
I missed a corner in Print Two, and haven’t yet done any detail pieces other than the wall with a pipe, so now is the chance to get both printed. There are a handful of 1×1 square detail pieces in the Sewer tile set, like ladders and corners that join the concave sewer walls.
The 1×1 detail tiles have terrific adhesion to the print bed; so much so that this print (or, rather, extracting this print from the printer) resulted in breaking a print trying to remove it from the print bed (first time for me, but certainly not the last). Ignoring the broken piece, a nice set of tiles:
- Series: OpenForge Tiles
- Maker: devonjones
- Source: OpenForge Sewers
- Original License: Creative Commons – Attribution – Share Alike
- Model Set: OpenForge Sewers – All
- Models:
- sewer_ladder_1x1.stl x3
- sewer_corner_convex.stl x3
- sewer_corner_concave.stl x3
- GCode: –
- Material: Prusa Gray PLA 1.75mm
- Print Date: 2017/09/22
- Print Time: 4 hours 41 minutes
- Estimated Print Time: 4 hours 5 minutes (PrusaControl)
- Estimated Filament: 29.2 meters (PrusaControl)
- Slicer: Slic3r PE 1.36.2
- Slice Settings:
- 0.35mm Fast Print
- 10% infill cubic
- no supports
- Printer: Prusa i3 mk2