We’re building a dungeon. This is a project spanning lots of different prints, until we generate all of the tiles we need for the dungeon we have in mind. The prints are spread across:
- Summary – The Sewer Dungeon
- Print One – Sewer Corners
- Print Two – Sewer Tunnel
- Print Three – Corners and Ladders
- Print Four – Deep Pool
- Print Five – Deep Sluice and Deep Pool
- Print Six – Barred Sewer
- Print Seven – ABS Flooring
- Print Eight – Circular Room Part 1
- Print Nine – Circular Room Part 2
- Print Ten – Circular Room Part 3
- Print Eleven – Bridges
- Print Twelve – So Much Sluice
- Print Thirteen – Magic Portal
Print Six – Barred Sewer
Having a completely open and easy to explore dungeon in the sewer seems like a missed opportunity – so I’m adding to the mystery (and explorable area) with a barred off section of the sewer. Not sure yet if the bars will be in place, bent, or broken:
There are four individual pieces to print for this model, and which to print depends on how wide the barred opening will be. I chose an opening with a 2 block wide sluice between the sides of the sewer, but printed the bars_top-3x.stl the first time around by mistake, which is too short to span a 2x wide sluice tile. The proper 4x wide topper for the bars got added to a later print.
- Series: OpenForge Tiles
- Maker: devonjones
- Source: OpenForge Barred Sewer
- Original License: Creative Commons – Attribution – Share Alike
- Model Set: OpenForge Barred Sewer – All
- Models:
- sewer_wall_2x1_a.stl
- sewer_wall_2x1_b.stl
- sewer_sluice_straight_barred.stl
- bars_top-4x.stl
- GCode: sewer_barred_01.gcode
- Material: Prusa Gray PLA 1.75mm
- Print Date: 2017/09/24
- Print Time: 2 hours 41 minutes
- Estimated Print Time: 2 hours 38 minutes (PrusaControl 0.9.3_390_beta)
- Estimated Filament: 19 meters meters (PrusaControl 0.9.3_390_beta)
- Slicer: Slic3r PE 1.37.1
- Slice Settings:
- 0.35mm Fast Print
- 10% infill cubic
- no supports
- Brim Size: 2mm
- Printer: Prusa i3 mk2
One Comment Add yours