Full Scale Totem

I really enjoyed the look and quality of the Monument Valley Totem model I printed
at half scale, and decided shortly after that print that a full scale print of the model was in order.

I quickly printed the first pieces, and it was clear that at full scale, this was going to be a large Totem:

The larger pieces each took a few hours to print over a few days, and I had started cleaning up the supports I had printed for the cubic body pieces, when I had a bit of a mishap that landed me in urgent care:

While I waited for the cut to heal, and stitches to get taken out, build out of the full Totem model was put on hold. Other things needed printing, and Totem ended up on a shelf until a little more than a month later, when I finally finished the clean up of the prints, and glued all of the surface details in place:

The glue cured overnight, and the next morning I snapped the pieces together:

Unlike the 50% scale print, where the prongs of the ring joint completely snapped off, resulting in the print being glued together, only a tiny number of the ring joint prongs broke during assembly of the full scale version.

 

  • Maker: AliG3D
  • Source: Totem a Friend Monument Valley plus Ida
  • License: Creative Commons – Attribution
  • Models: All Models
  • GCode: –
  • Materials:
    • Hatchbox Yellow PLA 1.75mm
    • Inland Turquoise PLA 1.75mm
    • Prusa Black PETG 1.75mm
    • Prusa White PLA 1.75mm
    • Inland Orange ABS 1.75mm
  • Print Date: 2017/10/30 – 2017/11/05
  • Print Time:
    • Yellow #1: 5 hours 1 minute
    • Yellow #2: 5 hours 47 minutes
    • Yellow #3: 5 hours 46 minutes
    • Yellow #4: 5 hours 21 minutes
    • Blue #2: 29 minutes
    • Blue #3: 55 minutes
    • Blue #4: 31 minutes
    • Black: 12 minutes
    • Orange: 11 minutes
    • White: 27 minutes
  • Estimated Print Time:
    • Yellow #1: 5 hours 4 minutes
    • Yellow #2: 5 hours 43 minutes
    • Yellow #3: 5 hours 43 minutes
    • Yellow #4: 5 hours 18 minutes
    • Blue #2: 28 minutes
    • Blue #3: 54 minutes
    • Blue #4: 31 minutes
    • Black: 11 minutes
    • Orange: 7 minutes
    • White: 26 minutes
  • Estimated Filament:
    • Yellow #1: 56.6 meters
    • Yellow #2: 56.9 meters
    • Yellow #3: 56 meters
    • Yellow #4: 54.3 meters
    • Blue #2: 3 meters
    • Blue #3: 5.5 meters
    • Blue #4: 3.2 meters
    • Black: 1.5 meters
    • Orange: 84.2 cm
    • White: 3.3 meters
  • Slicer: PrusaControl
  • Slicer Settings:
    • 0.35mm layers
    • 20% infill
    • Supports on build plate
    • Include brim
  • Printer: Prusa i3 mk2

Leave a Reply

Your email address will not be published.