Minions of a dangerous foe have a captive Bulette barely contained in a cage deep in the Undermountain. Nearly berserk with rage, the Bulette is likely as dangerous to the captors as to the adventurers. Post print this model was relative easy to clean up, with support material holding up the bulk of the body: View this post…
Doll House Dining set
A piece of doll-house scale furniture broke as the kids were cavorting around the living room – the project for the morning became designing a replacement, as well as a chair to go with the table. The table is modeled after our dining room table: View this post on Instagram A post shared by Dwyer Devices (@dwyerdevices) The…
Bestiary – Manticore
A Manticore joins the bestiary of interesting (and quite dangerous) creatures queued up for the adventurers. View this post on Instagram A post shared by Dwyer Devices (@dwyerdevices) The manticore is modeled as five separate pieces. Cleaning up printed sections took a fair amount of effort, as did filing down the wing joints to properly attach…
Glowing Moon
I’ve seen a lot of 3D printed glowing moons for sale on various Etsy shops, and all over Instagram, and wanted to print one for the 10 year old for Christmas. After a few failed moon prints I finally found a design that would work. View this post on Instagram A post shared by Dwyer Devices (@dwyerdevices) Pre-scaled…
High Detail Printing – Great Buddha
The Scan the World collection on MyMiniFactory has some great pieces spanning world history. For a number of reasons, this scan of the Great Buddha at Kamakura caught my eye. View this post on Instagram A post shared by Dwyer Devices (@dwyerdevices) I did two test prints with this model, working for the first time with…
Dragon/Snake Bracelet
A simple braided bracelet with a dragon/snake motif, printed in Red Copper PLA. View this post on Instagram A post shared by Dwyer Devices (@dwyerdevices) I’ve seen the design variously referred to as Celtic, Nordic, Viking, or Asian influenced, depending on who printed the bracelet or wrote about the design. The bracelet required a fair…
Final Fantasy XV – Chocobo
At full scale and fine resolution, this would take a little over 4 days just to print the body of the chocobo. I want more along the lines of action figure / 38mm scale, so I initially printed at 25% of original model scale. At that scale it’s a bit to small – clean up is difficult,…
4 Kilometer Token
The printer was well past 4 kilometers of printed filament before I noticed. Time for another token! View this post on Instagram A post shared by Dwyer Devices (@dwyerdevices) At the current print velocity, we’ll be adding another kilometer of printed filament nearly every month. Maker: patricknevindwyer Source: 4km Token Model: 4km coin.sl Material: Inland Silver…