Undermountain Dungeon – Print 3

We’re building another dungeon, this time the Undermountain. The Undermountain is a series of tunnels and rooms that once belonged to a dwarven stronghold, but have been taken over by an ancient wyrm and its devout goblin worshipers. This is a project spanning lots of different prints, until we generate all of the tiles we need for the dungeon we have in mind. The prints are spread across:

Portals

The adventurers have been pulled through a portal from the Sewer Dungeon, and into the Undermountain. Ahead of them lies the portal chamber, with three other hallways leading to what can only be more portals. Dominating the portal chamber are a set of obelisks, one for each hallway. Three of the obelisks stand tall, with a barely discernible glow, while another is sundered, the cracked spire fallen to the side of hte obelisk plinth.

At the end of two of the unexplored hallways are portals, each faintly glowing- one blue as the sky, the other the yellow of sand left to bake in the sun.

The completed portals are embedded in a 4×4 gray exterior:

 

  • Maker: devonjones
  • Source: OpenForge – Magic Circle Tiles
  • License: Creative Commons – Attribution – Share Alike
  • Models:
  • GCode: –
  • Materials:
    • Hatchbox Yellow PLA 1.75mm
    • GizmoDorks Translucent Blue PLA 1.75mm
    • Inland Gray ABS 1.75mm
  • Print Date: 2017/11/04 – 2017/11/8
  • Print Time:
    • Seven Oasis Portal: 2 hours 15 minutes
    • City in the Sky Portal: 2 hours 15 minutes
    • Circle Border (x3): 54 minutes
  • Estimated Print Time:
    • Seven Oasis Portal: 1 hour 57 minutes
    • City in the Sky Portal: 1 hours 57 minutes
    • Circle Border (x3): 42 minutes
  • Estimated Filament:
    • Seven Oasis Portal: 13.7 meters
    • City in the Sky Portal: 13.7 meters
    • Circle Border (x3): 6.1 meters
  • Slicer: Slic3r
  • Slicer Settings;
    • 0.35mm layers
    • 10% infill
    • 10mm brim
  • Printer: Prusa i3 mk2

One Comment Add yours

Leave a Reply

Your email address will not be published.