We’re building a dungeon. This is a project spanning lots of different prints, until we generate all of the tiles we need for the dungeon we have in mind. The prints are spread across: Summary – The Sewer Dungeon Print One – Sewer Corners Print Two – Sewer Tunnel Print Three – Corners and Ladders Print Four –…
Category: 3d printing
Sewer Dungeon – Print Three
We’re building a dungeon. This is a project spanning lots of different prints, until we generate all of the tiles we need for the dungeon we have in mind. The prints are spread across: Summary – The Sewer Dungeon Print One – Sewer Corners Print Two – Sewer Tunnel Print Three – Corners and Ladders Print Four –…
Sewer Dungeon – Print Two
We’re building a dungeon. This is a project spanning lots of different prints, until we generate all of the tiles we need for the dungeon we have in mind. The prints are spread across: Summary – The Sewer Dungeon Print One – Sewer Corners Print Two – Sewer Tunnel Print Three – Corners and Ladders Print…
Sewer Dungeon – Print One
We’re building a dungeon. This is a project spanning lots of different prints, until we generate all of the tiles we need for the dungeon we have in mind. The prints are spread across: Summary – The Sewer Dungeon Print One – Sewer Corners Print Two – Sewer Tunnel Print Three – Corners and Ladders Print Four –…
Ruined Walls
Let’s build a dungeon. We’ll start with some basic stone surface tiles with ruined walls. Perfect for a dilapidated building. View this post on Instagram A post shared by Dwyer Devices (@dwyerdevices) After our OpenForge Test Print, we’re scaling things up to print two tiles at a time. It won’t optimize anything or save any print time,…
OpenForge Test Print – Curved Wall
Building dungeons with typical purchased dungeon tiles can be an exercise in frustration – the tiles you have (or don’t have) end up dictating the layout and scope of the dungeon, rather than the story and setting. This curved tile served as a test print of the OpenForge series tile sets. View this post on Instagram A post…
Heart of TeFiti
Moana is kind of a big deal, especially around our house. We don’t sing songs from Frozen, we sing songs from Moana. Lo and behold a handful of Moana artifacts on Thingiverse: Maui, Pua and Hei-Hei, somehow not a single good Moana, a Kakamora Chief, and of particular interest a Heart of TeFiti. A Heart of TeFiti to…
Polyhedron – Truncated Icosidodecahedron
I have a mild obsession with polyhedra. The more complicated, intersecting, stellated, the better. I’ve got a stack of books on building polyhedra from paper, variations on polyhedra… it’s a bit much sometimes. And then I stumbled across two things on Thingiverse: Customizers A convex polyhedra customizer I may have lost a few hours to playing with…